LEMON Manuals: Even more car manuals for everyone
Home >> Fiat >> 2018 >> 124 Spider Classica, Automatic Trans >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Fuel Delivery >> Module, Fuel Pump >> Removal And Installation >> Submerged Pump Assembly Equipped With Level Gauge >> Removal

Submerged Pump Assembly Equipped With Level Gauge: Removal

  1. Open the fuse box cover in the engine compartment, remove fuse F34 (15A) and start the engine several times until the fuel pressure in the distribution manifold is expended.
  2. Fit the fuse removed previously and close the fuse box casing.
  3. Disconnect and isolate the negative battery cable.
  4. Remove the floor console. Refer to CONSOLE, FLOOR, REMOVAL AND INSTALLATION .
  5. Remove the door scuff plate. Refer to PLATE, SCUFF, DOOR, REMOVAL AND INSTALLATION .
    GC0176145Courtesy of CHRYSLER GROUP, LLC
  6. Recline the seat forward and using a suitable trim tool, remove the roll bar lining from its housing (1a), by disengaging the retainers (1b).
    GC0176245Courtesy of CHRYSLER GROUP, LLC
  7. Remove the fastener (1a) and remove the front seat belt (1b).
  8. Remove the front seat belt lining (2).
    GC0175693Courtesy of CHRYSLER GROUP, LLC
  9. Remove the fastener (1a) of the lining on rear panel (1b).
    GC0175995Courtesy of CHRYSLER GROUP, LLC
  10. Remove the hood release lever (1).
  11. Release the fastener (2) and disengage the clips from the roll bar lower lining.
    GC0175982Courtesy of CHRYSLER GROUP, LLC
  12. Disconnect the electrical connection (1) of the seat belt.
  13. Undo the upper bolts (2a) of the seat belt (2b) and move it outside the working area.
    GC0175600Courtesy of CHRYSLER GROUP, LLC
  14. Using a suitable trim tool remove the lower fastener (1a) and the upper fastener (1b).
  15. Release and put aside the wiring (2a) of the heated rear window and remove the soft top compartment side lining from its housing (2b).
    GC0175399Courtesy of CHRYSLER GROUP, LLC
  16. Remove the lower (1a) and upper fasteners (1b) of the soft top housing compartment lining.
    GC0175741Courtesy of CHRYSLER GROUP, LLC
  17. Remove the soft top housing compartment lining from its housing.
    GC0176422Courtesy of CHRYSLER GROUP, LLC
  18. Disengage the wiring from the retainer (1).
  19. Undo the screws (2a) and remove the fuel pump module cover (2b).
    GC0176441Courtesy of CHRYSLER GROUP, LLC
  20. Disconnect the electrical connection of the fuel pump module (1a), and release the quick coupling and disconnect the fuel pipe (1b).
  21. Undo the screws (2a) for the ring nut (2b).
    GC0176350Courtesy of CHRYSLER GROUP, LLC
  22. Remove the fuel pump module (1a) from the tank and keep the gasket (1b).