LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1993 >> Vision TSi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 3.3L/3.5L >> Self-Diagnostic System >> Entering On-Board Diagnostics >> CHECK ENGINE Light Diagnostic Mode

CHECK ENGINE Light Diagnostic Mode

  1. Start engine (if possible). Move transmission shift lever through all positions, ending in Park. Turn A/C switch on and then off (if equipped).
  2. Turn engine off. Without starting engine again, turn ignition on, off, on, off and on within 5 seconds. Record 2-digit fault codes as displayed by flashing CHECK ENGINE light.
  3. For example, fault code 23 is displayed as flash, flash, 4-second pause, flash, flash, flash. After a slightly longer pause, other codes stored are displayed in numerical order.
  4. When CHECK ENGINE light begins to flash fault codes, it cannot be stopped. Start over if count is lost. Code 55 indicates end of fault code display.
  5. Refer to FAULT CODES/MESSAGE table to translate trouble code number to a DRB-II fault message. Once trouble area is identified, re-fer to TEST FC-1A. Use DRB-II fault messages to find appropriate test.
  6. As an example, a 3.0L engine starts and runs but has a driveability problem. CHECK ENGINE light indicates a Code 14. Refer to FAULT CODES/MESSAGES to translate trouble code number to a DRB-II fault message.
  7. When DRB-II fault message is obtained, refer to appropriate test number. To clear fault codes, see CLEARING FAULTS .