LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1993 >> Vision TSi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 3.3L/3.5L >> No-Start Tests >> Test NS-3A - Inspecting Mechanical System

Test NS-3A - Inspecting Mechanical System

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For appropriate wiring diagram, see WIRING DIAGRAMS  at end of article.
  1. Disconnect Manifold Absolute Pressure (MAP) sensor connector. Turn ignition on. Using DRB-II, check voltage of MAP sensor connector 5-volt supply wire (Violet/White wire). If voltage is less than 4.5 volts, repair open MAP sensor 5-volt supply wire. Perform TEST VER-1.
  2. If voltage is more than 4.5 volts, reconnect MAP sensor connector. Remove all spark plugs. Inspect spark plug tips for wet fuel. If spark plug tips are wet, clean spark plugs.
  3. If spark plug tips are not wet, reinstall spark plugs. Using DRB-II, read total spark advance while cranking engine. If spark advance is not 0-25 degrees BTDC, replace Powertrain Control Module (PCM). Perform TEST VER-1. If spark advance is 0-25 degrees BTDC, go to next step.
  4. Inspect spark plug cables for correct placement. Reposition wires as required. Perform TEST VER-1. If spark plug cables are okay, turn ignition off. Check valve timing. Correct valve timing as required. Perform TEST VER-1.
  5. If valve timing is okay, check engine compression. Repair as required. Perform TEST VER-1. If engine compression is okay, replace MAP sensor. Perform TEST VER-1.