LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1993 >> Vision TSi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 3.3L/3.5L >> No-Start Tests >> Test NS-1A - Qualifying No Start Condition

Test NS-1A - Qualifying No Start Condition

CAUTION: When checking for spark, powertrain control module damage may occur if spark plug cable is held more than 1/4" away from a good ground.
  1. Turn ignition off. Disconnect any spark plug cable at spark plug. Insert an insulated screwdriver in spark plug cable terminal. Hold screwdriver within 1/4" of good ground.
    NOTE: When checking for spark, consider one or two sparks as a no spark condition.
  2. While cranking engine for 10 seconds, watch for spark. If a good spark occurs, go to TEST NS-2A. If a good spark does not occur, reconnect spark plug cable. Disconnect another spark plug cable at spark plug, and repeat test.
  3. If a good spark occurs, replace spark plug cable that was initially used to test for spark. If a good spark does not occur, disconnect ignition coil connector. Inspect all terminals. Repair as required. Perform TEST VER-1. If terminals are okay, replace ignition coil. Perform TEST VER-1.