LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1993 >> Vision TSi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 3.3L/3.5L >> No Fault Tests >> Test NF-9A - Checking Solenoid Operations

Test NF-9A - Checking Solenoid Operations

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For appropriate wiring diagram, see WIRING DIAGRAMS  at end of article.
  1. Using DRB-II, actuate purge solenoid. While touching top of canister purge solenoid, feel for operation. If purge solenoid does not operate, replace canister purge solenoid. Perform TEST VER-2.
  2. If purge solenoid operates, actuate EGR solenoid. While touching top of EGR valve, feel for operation. If EGR solenoid does not operate, replace EGR solenoid. Perform TEST VER-2. If EGR solenoid operates, go to next step.
  3. If vehicle is equipped with a 3.3L engine and solenoids are operating normally, test is complete. If vehicle is equipped with a 3.5L engine, actuate Manifold Tuning Valve (MTV) solenoid.
  4. While touching top of MTV solenoid, feel for operation. If MTV solenoid does not operate, replace MTV solenoid. Perform TEST VER-2. If MTV solenoid operates, start engine and let idle for one minute to build up vacuum. Turn engine off. Turn ignition on. Actuate MTV valve.
  5. If MTV valve opens and closes fully when actuated, MTV solenoid and valve are operating properly. Test is complete. If MTV valve does not open and close fully when actuated, go to next step.
  6. Inspect MTV valve vacuum hose for leaks. Repair as required. Perform TEST VER-2. If no vacuum leaks are observed, replace MTV valve. Perform TEST VER-2.