LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1993 >> Vision TSi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 3.3L/3.5L >> No Fault Tests >> Test NF-8B - Checking Idle Air Control Motor

Test NF-8B - Checking Idle Air Control Motor

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For appropriate wiring diagram, see WIRING DIAGRAMS  at end of article.

Turn engine off. Disconnect Powertrain Control Module (PCM). Using an external ohmmeter, check resistance on each wire between Idle Air Control (IAC) motor connector and Powertrain Control Module (PCM) connector. See PCM TERMINAL IDENTIFICATION table. If resistance for any wire was more than 10 ohms, repair open as necessary. Perform TEST VER-2. If resistance for any wire was less than 10 ohms, replace PCM. Perform TEST VER-2.

PCM TERMINAL IDENTIFICATION

Wire Color Terminal No.
Gray/Red 39
Brown/White 40
Violet/Black 59
Yellow/Black 60