LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1993 >> Vision TSi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 3.3L/3.5L >> No Fault Tests >> Test NF-6A - Checking Manifold Absolute Pressure (Map) Sensor

Test NF-6A - Checking Manifold Absolute Pressure (Map) Sensor

CALIBRATION

  1. Turn engine off. Install "T" into a manifold vacuum source. Install vacuum gauge. Start engine, and let it idle. If engine will not idle, maintain a constant RPM above idle. Using DRB-II, read MAP gauge value. If reading is within one in. Hg of vacuum gauge reading, test is complete. Perform TEST VER-2. If reading is not within one in. Hg of vacuum gauge reading, replace MAP sensor.
  2. Turn engine off. Disconnect vacuum gauge from MAP sensor vacuum hose. Connect an auxiliary vacuum pump to MAP sensor. Apply 5 in. Hg to MAP sensor. Read and record MAP sensor voltage. Increase vacuum to 20 in. Hg. Read and record MAP sensor voltage. Subtract voltage recorded at 20 in. Hg from voltage recorded at 5 in. Hg.
  3. If difference is 2.3-2.9 volts, repair restriction in vacuum hose to MAP sensor. Perform TEST VER-2. If voltage difference is not 2.3-2.9 volts, replace MAP sensor. Perform TEST VER-2.