LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1993 >> Vision TSi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 3.3L/3.5L >> No Fault Tests >> Test NF-3B - Checking Fuel Pressure

Test NF-3B - Checking Fuel Pressure

WARNING: High fuel pressure may be present in fuel lines. Open fuel system with caution. See FUEL PRESSURE RELEASE procedure.
  1. Release fuel pressure. Using DRB-II, stop fuel system actuation test. Ensure fuel tank is at least 1/4 full before performing following test. Install fuel pressure gauge and adapter between fuel tank and filter at rear of vehicle.
  2. Remove fuel return line from fuel pump at fuel tank. Connect Fuel Pressure Test Adapter (6541) to fuel return line. Place other end of adapter hose into an approved 2-gallon gasoline can. Turn ignition on.
  3. Using DRB-II, actuate fuel system test. Observe fuel pressure gauge. If fuel pressure is 50-60 psi (3.3L) or 43-53 psi (3.5L), repair fuel return line for a restriction at fuel tank. Perform TEST VER-2.
  4. If fuel pressure is not 50-60 psi (3.3L) or 43-53 psi (3.5L), stop fuel system actuation test. Release fuel pressure. Reconnect fuel return line to fuel tank. Disconnect fuel return line from fuel rail.
  5. Attach Fuel Pressure Test Adapter (6541) to fuel return line nipple at fuel rail. Place other end of adapter hose into an approved 2-gallon gasoline can. Turn ignition on. Actuate fuel system test. Observe fuel pressure gauge.
  6. If fuel pressure is 50-60 psi (3.3L) or 43-53 psi (3.5L), repair restricted fuel return line to fuel tank. Perform TEST VER-2. If fuel pressure is not 50-60 psi (3.3L) or 43-53 psi (3.5L), inspect fuel pressure damper line for restrictions.
  7. If restrictions exist, replace fuel pressure damper line. Perform TEST VER-2. If no restrictions exist, replace fuel pressure regulator. Perform TEST VER-2.