LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1993 >> Vision TSi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 3.3L/3.5L >> No Fault Tests >> Test NF-2A - Checking Secondary Ignition & Timing

Test NF-2A - Checking Secondary Ignition & Timing

  1. Turn engine off. Connect engine analyzer to engine. Start engine, and let it idle. Set scope to read display or parade pattern. Follow equipment manufacturer's procedure for pattern analysis.
  2. If secondary ignition pattern is not okay, repair indicated component in secondary ignition system. Perform TEST VER-2. If secondary ignition pattern is okay, remove all lower spark plug wires one at a time from ignition coil. Observe secondary kilovolt line.
  3. If open circuit secondary voltage is not at least 25 kV, replace electronic ignition coil. Perform TEST VER-2. If open circuit secondary voltage is at least 25 kV, reinstall spark plug wire(s).
  4. Ensure engine temperature is more than 180°F (82°C) before proceeding. Using DRB-II, read spark advance. Increase engine speed to 2000 RPM. If spark advance does not change with increase in RPM, replace Powertrain Control Module (PCM). Perform TEST VER-2. If spark advance changes with increase in RPM, test is complete.