Test FC-44A - No CCD Message From TCM (DTC 66)
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION . For appropriate wiring diagram, see WIRING DIAGRAMS at end of article.
- Turn ignition on. Using DRB-II, select TRANSMISSION and then EATX. If DRB-II does not display BUS OPERATIONAL, see appropriate article in the ENGINE PERFORMANCE Section. If DRB-II displays BUS OPERATIONAL, go to next step.
- If DRB-II displays NO RESPONSE, repair automatic transmission. If DRB-II does not display NO RESPONSE, go to next step.
- Using DRB-II, select ENGINE and erase faults. Start engine. Let idle for one minute. Read faults. If DRB-II displays NO CCD MESSAGE FROM TCM, go to step 6). If DRB-II does not display NO CCD MESSAGE FROM TCM, go to next step.
- At this time, the condition required to set fault is not present. NO CCD MESSAGE FROM TCM fault sets when Powertrain Control Module (PCM) does not receive any messages from Transmission Control Module (TCM) across CCD bus for 10 seconds. Possible causes are: CCD bus failure, open CCD (+) circuit, open CCD (-) circuit, failed PCM, no power to TCM, or failed TCM.
- Inspect wiring and connectors, Repair as required. Perform TEST VER-2. If wiring and connectors are okay, see INACTIVE FAULT CONDITION . Perform TEST VER-2.
- If DRB-II displayed NO CCD MESSAGE FROM TCM in step 3), turn ignition off. Disconnect PCM connector. Disconnect TCM connector. Using an external ohmmeter, check resistance of CCD (-) wire (White/Black wire) between PCM connector terminal No. 46 and TCM connector terminal No. 4.
- If resistance is more than 5 ohms, repair CCD (-) wire for an open. Perform TEST VER-2. If resistance is less than 5 ohms, go to next step.
- Using an external ohmmeter, check resistance of CCD (+) wire (Violet/Brown wire) between PCM connector terminal No. 26 and TCM connector terminal No. 43. If resistance is more than 5 ohms, repair CCD (+) wire for an open. Perform TEST VER-2. If resistance is more than 5 ohms, replace PCM. Perform TEST VER-2.