LEMON Manuals: Even more car manuals for everyone
Home >> Eagle >> 1993 >> Vision TSi >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 3.3L/3.5L >> Fault Code Tests >> Test FC-42B - Ignition Coil #3 Primary Circuit

Test FC-42B - Ignition Coil #3 Primary Circuit

NOTE: For connector terminal identification, see CONNECTOR IDENTIFICATION . For appropriate wiring diagram, see WIRING DIAGRAMS  at end of article.
  1. Turn ignition off. Disconnect Auto Shutdown (ASD) relay. Using an external ohmmeter, check resistance of output wire (Dark Green/Orange wire) between ASD relay connector terminal "D" and ignition coil con-nector.
  2. If resistance is more than 5 ohms, repair ASD output wire for an open. Perform TEST VER-2. If resistance is less than 5 ohms, turn ignition on. Place DRB-II in voltmeter mode. Using DRB-II, check voltage of ASD relay connector B+ wire (Red/White wire).
  3. If voltage is less than 10 volts, repair B+ wire for an open. Perform TEST VER-2. If voltage is more than 10 volts, use DRB-II to check voltage of ASD relay connector ignition feed wire (Dark Blue/White wire). If voltage is less than 10 volts, repair ignition feed wire for an open. Perform TEST VER-2.
  4. If voltage is more than 10 volts, turn ignition off. Disconnect fuel pump relay. Using an external ohmmeter, check resistance of relay control wire (Dark Blue/Yellow wire) between ASD relay connector terminal "C" and fuel pump relay terminal "C".
  5. If resistance is more than 5 ohms, repair ASD control wire for an open. Perform TEST VER-2. If resistance is less than 5 ohms, replace ASD relay. Perform TEST VER-2.