LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2025 >> Durango R/T Plus >> Repair and Diagnosis >> Body & Frame >> Seats >> Power Seats (Service Information) >> Switch, Lumbar Control >> Installation

Switch, Lumbar Control: Installation

NOTE: Left hand drive model shown in illustration. Right hand drive model similar.
  1. Connect the wiring harness connector (2) to the power lumbar support switch (4). Make sure the connector is fully engaged.
    GC0209884Courtesy of CHRYSLER GROUP, LLC
  2. Position the power lumbar support switch to the seat cushion side trim panel (1) and engage the retaining tabs (3 and 5) to the trim panel. Make sure the retaining tabs are fully engaged.
    GC0209887Courtesy of CHRYSLER GROUP, LLC
  3. Position the seat cushion side trim panel (2) to the seat.
  4. Slide the seat cushion side trim panel rearward and engage the trim panel to the three mounting brackets located on the outboard seat frame (3).
  5. Install and securely tighten the seat cushion side trim panel screw (1) to the seat frame.
    GC0209883Courtesy of CHRYSLER GROUP, LLC
  6. Carefully engage the tabs (2) securing the seat cushion side trim panel (3) to the rear of the seat (1). Make sure the retaining tabs are fully engaged.
    GC0209882Courtesy of CHRYSLER GROUP, LLC
  7. Install the seat belt anchor trim panel (1) onto the outboard seat cushion side trim panel (2). Make sure the trim panels are fully engaged.
  8. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
  9. Verify the power seat for proper operation.