Body Control Module (BCM) Enhancement (08-112-17)
Reference number: 08-112-17
Supersedes refnos: 08-032-18
BODY CONTROL MODULE (BCM) ENHANCEMENT
TECHNICAL SERVICE BULLETIN
| CHRYSLER: | 2018 Dodge Durango (WD) |
| GROUP: | 08 - Electrical |
THIS SERVICE BULLETIN IS ALSO BEING RELEASED AS RAPID RESPONSE TRANSMITTAL (RRT) **18-024**. ALL APPLICABLE SOLD AND UNSOLD RRT VIN's HAVE BEEN LOADED. TO VERIFY THAT THIS RRT SERVICE ACTION IS APPLICABLE TO THE UNSOLD VEHICLE, USE VIP OR PERFORM A VIN SEARCH IN TECHCONNECT. ALL REPAIRS ARE REIMBURSABLE WITHIN THE PROVISIONS OF WARRANTY.
THE wiTECH SOFTWARE IS REQUIRED TO BE AT THE LATEST RELEASE BEFORE PERFORMING THIS PROCEDURE.
SUBJECT
Body Control Module (BCM) Enhancement
OVERVIEW
This bulletin involves re-configuring the BCM with the latest available software to correct Transmission Drive Mode missing on performance pages.
MODELS
| 2018 | (WD) | Dodge Durango |
SYMPTOM/CONDITION
**The customer may notice that the transmission drive mode feature is not displaying on the radio, in the performance page or some vehicles show "Drag Mode" when it should show "Track Mode" (Fig. 1) .**
DIAGNOSIS
If a customer's VIN is listed in VIP or your RRT VIN list, perform the repair. If any vehicle not on the VIN list exhibits the symptom/condition, perform the repair.
REPAIR PROCEDURE
- Using wiTECH, re-configure the BCM to the vehicle. This routine is available under the "Diagnostic Procedures" tab found on the home, 'Vehicle View', page of wiTECH.
- **Using wiTECH, perform a hard reset on the radio. This routine can be found in "Guided Diagnostic", select "ECU Reset" and then select "Radio". This routine must be performed twice.**
- Verify that the Transmission Mode line is now present **and says "Track Mode" (Fig. 2)
.**
- Using wiTECH clear any DTCs which may have been set during the reconfiguration.
POLICY
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE
| Labor Operation No: | Description | Skill Category | Amount |
|---|---|---|---|
| **18-19-02-DD** | Module, Body Control (BCM) Reconfigure Vehicle - Powernet (0 - Introduction) | 6 - Electrical and Body Systems | 0.2 Hrs. |
FAILURE CODE
The dealer must choose which failure code to use depending on if this is a Rapid Response Transmittal (RRT) or Service Bulletin.
- If the customer's concern matches the SYMPTOM/CONDITION identified in the Service Bulletin, failure code CC is to be used. When utilizing this failure code, the 3C's must be supplied.
- The failure code "RF" (Required Flash) can no longer be used on Service Bulletin flashes. The "RF" failure code can only be used on RRT.
- The "RF" failure code is required for essential module flash/reprogramming and can only be used after confirmation that the VIN is included on the RRT.
| CC | Customer Concern |
| RF | Required Flash |