Antenna, Remote Start: Installation
NOTE:
Left side shown in illustration. Right side similar.
- Install the Remote Start Receiver (1) to the body of the vehicle indicated.
- Route the Remote Start Antenna and clip in place with the provided fasteners (2).
- Position the quarter trim panel (2) back into the vehicle.NOTE:
Right side shown in illustration, left side similar.
- Position the front locating pin into the body and seat the push pin near the location pin fully.
- Seat the clip at the top of the trim panel into the C-pillar first.
- For the right side, seat the three front push pins.
- For the left side, seat the two front push pins.
- Seat the push pin at the rear of the quarter glass.
- For the right side, connect the power outlet electrical connector (1).
- For the left side, connect the flash light electrical connector and the power liftgate switch, if equipped.
- Position the rear locating pin into the body and seat the remaining push pins (5).
- Install the screws (4).NOTE:
Screw cap (3) must be discarded when ever it is removed and replaced with a new one.
- Install a new screw cap (3).
- Position the door weatherstrip (1) back and seat fully.
- Install the rear door scuff plate. Refer to PLATE, SCUFF, LIFTGATE, INSTALLATION .
- Install the D-pillar trim. Refer to PANEL, D-PILLAR TRIM, INSTALLATION .
- Install the load floor. Refer to LOAD FLOOR, FOOTWELL, INSTALLATION .