Rear Outboard
To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Mopar® Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.
- Remove the trim panel from the upper quarter inner panel. Refer to PANEL, QUARTER TRIM, REMOVAL .
- Remove the screw (3) that secures the rear outboard seat belt lower anchor (2) to the quarter inner panel just forward of the rear wheel housing (1).
- Remove the screw (2) that secures the seat belt turning loop to the inside of the upper C-pillar.
- Remove the seat belt turning loop from the upper inner C-pillar.
- Remove the screw (3) that secures the retractor (4) lower bracket to the inner C-pillar.
- Lift the retractor upward far enough to disengage the retractor upper bracket T-tab from the keyed slot in the inner C-pillar.
- Remove the rear outboard seat belt and retractor from the vehicle as a unit.