LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2016 >> Durango R/T, AWD >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel System >> Fuel Injection, Gas >> Sensor, Crankshaft Position >> Removal >> 3.6L

Sensor, Crankshaft Position: Removal: 3.6L

The Crankshaft Position (CKP) sensor is mounted into the right rear side of the cylinder block.

  1. Disconnect and isolate the negative battery cable.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
    Fig 1: Crankshaft Position Sensor Connector
    GC0173636Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the Crankshaft Position (CKP) Sensor wire harness connector (1).
    Fig 2: Crankshaft Position Sensor Bolt
    GC0173724Courtesy of CHRYSLER GROUP, LLC
  4. Remove the CKP sensor bolt (1).
    Fig 3: Removing/Installing Crankshaft Position Sensor
    GC0173632Courtesy of CHRYSLER GROUP, LLC
  5. Carefully twist the CKP sensor (1) and remove from the cylinder block.
    Fig 4: CKP Sensor O-Ring
    GC0144246Courtesy of CHRYSLER GROUP, LLC
  6. The CKP sensor O-ring (1) can be reused if not damaged.