LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2014 >> Challenger SXT >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Restraints System (Service Information) >> Retractor, Seat Belt >> Installation >> Front Seat

Front Seat

Fig 1: Indexing Tabs, Squib Connector & Retaining Bolt
GC0132951Courtesy of CHRYSLER GROUP, LLC
  1. Position the retractor into the vehicle, inserting the indexing tabs (1) into the slots on the body.
  2. Install the front seat belt retractor retaining bolt (3). Tighten bolt to 32 N.m (24 ft. lbs.).
  3. Connect the tensioner electrical squib connector (2).
    Fig 2: Seatbelt Components
    GC0132950Courtesy of CHRYSLER GROUP, LLC
  4. Position the upper turning loop and install the two retaining bolts (1). Tighten bolt to 40 N.m (30 ft. lbs.).
  5. Install the lower quarter trim panel. Refer to PANEL, QUARTER TRIM, INSTALLATION .
    Fig 3: Lower Seat Belt Anchor Bolts
    GC0132949Courtesy of CHRYSLER GROUP, LLC
  6. Install the two lower seat belt anchor bolts (1).
  7. Do not reconnect the negative cable to the battery at this time. The Supplemental Restraint System (SRS) Verification Test procedure should be performed following service of any SRS component. Refer to STANDARD PROCEDURE .
WARNING:

Do not connect the battery negative cable. If the system test is not performed first it may result in serious or fatal injury.