Retractor, Seat Belt: Removal: Removal: Front
- Disconnect and isolate the negative cable from the battery. Wait two minutes for the system capacitor to discharge before further service.WARNING:
Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service. Failure to do so may result in accidental airbag deployment, and serious or fatal injury.
- Remove the two lower seat belt anchor bolts (1).
- Remove the lower quarter trim panel. Refer to PANEL, QUARTER TRIM, REMOVAL .
- Remove the two upper turning loop retaining bolts (1).
- Disconnect the tensioner electrical squib connector (2).
- Remove the front seat belt retractor retaining bolt (3).
- Remove the retractor by pulling inboard then upward releasing the indexing tabs (1).