LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2011 >> Durango R/T, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Rear Driveline Module) >> SEAL, Input Flange >> Removal >> Removal

SEAL, Input Flange: Removal: Removal

WARNING: This page is about a different car, the 2011 Jeep Patriot and 2011 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Electric Clutch AT Rear Axle
GC0083879Courtesy of CHRYSLER LLC
  1. Raise the vehicle on a hoist.
  2. Remove the propeller shaft. Refer to Removal .
  3. Unplug the electrical connector (3) at the ECC.
  4. Disconnect ECC breather hose.
  5. Remove the ECC to RDA mounting bolts.
  6. Separate and lower ECC.
  7. Remove all old gasket material on the mating surfaces of the ECC and RDA. Remove wave washer
  8. Remove wave washer.
    Fig 2: Remove Pinion Seal
    GC0083886Courtesy of CHRYSLER LLC
  9. Remove the input flange seal.