SENSOR, Crankshaft Position: Installation: 4.7L
WARNING: This page is about a different car, the 2011 RAM Dakota. However, it is still accessible from the selected car via links, so may be relevant.
- Clean out machined hole in engine block.
- Apply a small amount of engine oil to sensor o-ring.
- Install sensor (1) into engine block with a slight rocking and twisting action.CAUTION:
Before tightening sensor mounting bolt (2), be sure sensor is completely flush to cylinder block. If sensor is not flush, damage to sensor mounting tang may result.
- Install mounting bolt (2) and tighten to 28 N.m (21 ft. lbs.) torque.
- Connect electrical connector to sensor.
- Lower vehicle.