LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2011 >> Durango R/T, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Fuel System) >> Fuel Delivery >> RAIL, Fuel >> Installation >> 4.7L

RAIL, Fuel: Installation: 4.7L

WARNING: This page is about a different car, the 2011 RAM Dakota. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Ignition Coils - 4.7L
GC0082914Courtesy of CHRYSLER LLC
  1. If fuel injectors are to be installed. Refer to INJECTOR(S), Fuel, Installation .
  2. Clean out fuel injector machined bores in intake manifold.
  3. Apply a small amount of engine oil to each fuel injector o-ring. This will help in fuel rail installation.
  4. Position fuel rail/fuel injector assembly to machined injector openings in cylinder head.
  5. Guide each injector into cylinder head. Be careful not to tear injector o-rings.
  6. Push right  side of fuel rail down until fuel injectors have bottomed on cylinder head shoulder. Push left  fuel rail down until injectors have bottomed on cylinder head shoulder.
  7. Install four fuel rail mounting bolts (1) and tighten. Refer to SPECIFICATIONS  .
  8. Install 8 ignition coils. Refer to COIL, Ignition, Installation .
  9. Connect electrical connectors to throttle body.
    Fig 2: Remove/Install Injector Connector
    GC0092260Courtesy of CHRYSLER LLC
  10. Connect electrical connectors at all fuel injectors. Refer to graphic. Push connector onto injector (1) and then push and lock red colored slider (2). Verify connector is locked to injector by lightly tugging on connector.
  11. Connect necessary vacuum lines to throttle body.
  12. Install air resonator mounting bracket near front of throttle body (2 bolts).
  13. Connect fuel line latch clip and fuel line to fuel rail. Refer to FITTING, Quick Connect, Standard Procedure .
  14. Install air box to throttle body.
  15. Install air duct to air box.
  16. Connect battery cable to battery.
  17. Start engine and check for leaks.