LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2011 >> Durango R/T, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 146 (Rear Axle) >> Installation >> Installation

Section 146 (Rear Axle): Installation: Installation

WARNING: This page is about a different car, the 2011 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Lower Control Arm & Axle Brackets
GC0085811Courtesy of CHRYSLER LLC
CAUTION:

The weight of the vehicle must be supported by the springs before the control arms and track bar are tightened. Failure to follow these instructions will cause premature bushing failure.

  1. Raise the axle under the vehicle.
  2. Install lower control arms (1) onto the axle brackets (2). Loosely install mounting bolts and nuts.
  3. Install coil spring isolators and springs.
  4. Raise axle up until springs are seated.
    Fig 2: Identifying Upper Control Arm & Axle Brackets
    GC0085810Courtesy of CHRYSLER LLC
  5. Install upper control arms (1) into axle brackets (2). Loosely install mounting bolts and nuts.
    Fig 3: Identifying Shock Absorbers & Axle Brackets
    GC0085809Courtesy of CHRYSLER LLC
  6. Install shock absorbers (1) in axle brackets (2). Install shock bolts and nuts and tighten nuts to specifications.
    Fig 4: Identifying Stabilizer Bar & Axle Bracket
    GC0085808Courtesy of CHRYSLER LLC
  7. Install stabilizer bar (1) and clamps (2) on axle. Tighten clamp (2) bolts to torque specifications.
  8. Install vent hose to axle shaft tube.
    Fig 5: Identifying Track Bar & Axle Bracket
    GC0085807Courtesy of CHRYSLER LLC
  9. Install track bar (1) in axle bracket (2). Loosely install track bar (1) bolt.
    Fig 6: Identifying Brake Sensor & Axle
    GC0085806Courtesy of CHRYSLER LLC
  10. Install brake rotors, calipers and brake sensor (1) on axle (2).
  11. Install parking brake cables. Refer to CABLE, Parking Brake, Installation .
    Fig 7: Identifying Axle Flange & Propeller Shaft Flange
    GC0085727Courtesy of CHRYSLER LLC
  12. Install propeller shaft with pinion flange (1) and propeller shaft flange (2) reference marks aligned.
    NOTE:

    Clean all propeller shaft bolts and apply Mopar Lock AND Seal Adhesive or equivalent to the threads before installation.

  13. Install propeller shaft bolts and tighten to specifications.
  14. Install the wheels and tires.
  15. Remove lifting device from axle and lower the vehicle.
  16. Tighten lower control arms, upper control arms and track bar bolts to torque specifications.