LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2011 >> Durango R/T, AWD >> Repair and Diagnosis >> Engine Performance >> Ignition System (Service Information) >> Solenoid, Variable Valve Timing >> Removal >> Left VVT Solenoid(S)

Left VVT Solenoid(S)

Fig 1: Air Inlet Hose
GC0145457Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the negative battery cable.
  2. Disconnect the electrical connector (2) from the Inlet Air Temperature (IAT) sensor.
  3. Loosen the clamp (1) at the throttle body.
  4. Loosen the clamp (4) at the air cleaner body.
  5. Remove the air inlet hose (3).
    Fig 2: Variable Valve Timing Solenoid Connectors, Exhaust Variable Valve Timing Solenoid & Mounting Bolts
    GC0144208Courtesy of CHRYSLER LLC
    NOTE:

    Mark the variable valve timing solenoid connectors (1) with a paint pen or equivalent so that they may be reinstalled in their original locations.

  6. Mark the intake variable valve timing solenoid (4) and the exhaust variable valve timing solenoid (2) with a paint pen or equivalent so that they may be reinstalled in their original locations.
  7. Disconnect the electrical connector (1) from the variable valve timing solenoid.
  8. Remove the variable valve timing solenoid mounting bolts (3).
    Fig 3: Seal
    GC0144209Courtesy of CHRYSLER LLC
  9. Pull the variable valve timing solenoid from the cylinder head cover.
  10. The seal (1) can be reused if not damaged.