LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2011 >> Durango R/T, AWD >> Repair and Diagnosis >> Engine Performance >> Ignition System (Service Information) >> Coil, Ignition >> Removal >> 3.6L

Coil, Ignition: Removal: 3.6L

Fig 1: Air Inlet Hose
GC0145457Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the negative battery cable.
  2. If removing the ignition coils from cylinders 1 and 3 on the RH side of the engine, first remove the air inlet hose (3). Refer to MANIFOLD, INTAKE, REMOVAL or MANIFOLD, INTAKE, REMOVAL, 5.7L .
    Fig 2: Upper Intake Manifold
    GC0144183Courtesy of CHRYSLER LLC
  3. If removing the ignition coils from cylinders 2, 4 or 6 on the LH side of the engine, first remove the air inlet hose, upper intake manifold (2) and insulator. Refer to MANIFOLD, INTAKE, REMOVAL or MANIFOLD, INTAKE, REMOVAL, 5.7L .
    Fig 3: Electrical Connector, Ignition Coil Retaining Bolt & Ignition Coil
    GC0144206Courtesy of CHRYSLER LLC
    NOTE:

    The LH ignition coils are shown in illustration, the RH ignition coils are similar.

  4. Unlock and disconnect the electrical connector (1) from the ignition coil.
  5. Remove the ignition coil mounting bolt (3).
  6. Pull the ignition coil (2) from cylinder head cover opening with a slight twisting action.