LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2011 >> Durango R/T, AWD >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel System >> Fuel Injection, Gas >> Sensor, Crankshaft Position >> Removal >> 3.6L

Sensor, Crankshaft Position: Removal: 3.6L

Fig 1: Heat Shield
GC0144496Courtesy of CHRYSLER LLC

The crankshaft position (CKP) sensor is mounted into the right rear side of the cylinder block.

  1. Disconnect and isolate the negative battery cable.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  3. Remove the front suspension skid plate. Refer to PLATE, SKID, FRONT, REMOVAL or PLATE, SKID, FRONT SUSPENSION, REMOVAL .
  4. Push back the heatshield (1) from the crankshaft position (CKP) sensor.
    Fig 2: Electrical Connector
    GC0144243Courtesy of CHRYSLER LLC
  5. Disconnect the electrical connector (1) from the crankshaft position (CKP) sensor.
    Fig 3: Sensor Mounting Bolt & Sensor
    GC0144245Courtesy of CHRYSLER LLC
  6. Remove the sensor mounting bolt (2).
  7. Carefully twist the sensor (1) from the cylinder block.
    Fig 4: O-Ring
    GC0144246Courtesy of CHRYSLER LLC
  8. The CKP sensor O-ring (1) can be reused if not damaged.