LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2004 >> Neon SE, Automatic >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel Injection >> Throttle Body >> Installation >> Installation - 1.6L

Installation - 1.6L

NOTE: The electrical connector must be pointed toward the front of vehicle and purge nipple must be in the up position for proper orientation of the throttle body (Figure).
  1. Make sure that the mating surfaces for the throttle body and intake manifold are clean (Fig 1).
    Fig 1: Identifying Throttle Body And Intake Manifold Mating Surfaces (1.6L)
    G03538411Courtesy of DAIMLERCHRYSLER CORP.
  2. Install the throttle body making sure that the gasket is installed in the throttle body (Fig 2) and (Fig 3). Align the pin on the manifold gasket to the pin alignment hole in throttle body, make sure that the purge nipple is pointed up and electrical connector is pointed toward the front of vehicle.
    Fig 2: Installing Throttle Body Seal (1.6L)
    G03538412Courtesy of DAIMLERCHRYSLER CORP.
    Fig 3: Throttle Body Seal Installed (1.6L)
    G03538413Courtesy of DAIMLERCHRYSLER CORP.
  3. Install the 4 bolts to the throttle body (Figure). Tighten the bolts in a cross pattern to 11.8 N.m (105 in. lbs.).
  4. Connect the vacuum line from the throttle body.
  5. Connect the electrical connectors at the throttle body.
  6. Install the clean air duct at the throttle body.
  7. Connect the negative battery cable.