Fuel System/Misfire Monitor Verification Test
NOTE:
If replacing Powertrain Control Module (PCM), the correct vehicle mileage and Vehicle Identification Number (VIN) must be programmed into PCM to prevent Diagnostic Trouble Codes (DTC) from being stored in Controller Anti-Lock Brake (CAB) module and Air Bag Control Module (ACM).
- If any DTCs have not been diagnosed, perform appropriate diagnostic test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS table under DIAGNOSTIC TROUBLE CODE DEFINITIONS. If all DTCs have been diagnosed and repaired, go to next step.
- Inspect vehicle to ensure all engine components are connected. Reassemble and reconnect components as necessary, and go to next step.
- Connect DRBIII® scan tool to Data Link Connector (DLC), if not previously done. Go to next step.
- Ensure fuel tank is at least 1/4 full. Ensure all accessories are off. Go to next step.
- If repair procedure included replacing PCM, go to next step. If repair procedure did not include replacing PCM, go to step 8.
- Ensure the correct vehicle mileage and Vehicle Identification Number (VIN) are programmed into PCM to prevent Diagnostic Trouble Codes (DTC) from being stored in Controller Anti-Lock Brake (CAB) module and Air Bag Control Module (ACM). If vehicle is equipped with a Sentry Key Immobilizer Module (SKIM), secret key data must be updated to enable start.
- For SKIM theft alarm, using DRBIII®, select THEFT ALARM, SKIM, then MISC. Place SKIM in secured access mode by using appropriate PIN code for this vehicle. Select UPDATE SECRET KEY DATA. Data will be transferred from SKIM to PCM.
- Ensure that misfire detection is enabled if a misfire DTC was repaired. Low fuel level or an un-learned Adaptive Numerator can disable the misfire monitor.
- If repair procedure included replacing or disconnecting PCM, Adaptive Numerator must be relearned in order for misfire monitor to run.
- Using scan tool, monitor SIMILAR CONDITIONS and attempt to duplicate conditions during which vehicle was operating at when DTC was set.
- If conditions can be duplicated, GOOD TRIP counter will change to one or more. If conditions cannot be duplicated, clear DTCs. If any symptoms remain, check for any Technical Service Bulletins (TSB) that may apply to symptom. Go to appropriate TROUBLE SHOOTING - NO CODES article for diagnosis by symptom. If any DTC remain, proceed to appropriate DTC test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS .