LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2002 >> Ram Van B2500, Van Cargo, 5.9 Z >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Diagnostic Tests >> DTC P1282: Fuel Pump/System Relay Control Circuit >> Testing

DTC P1282: Fuel Pump/System Relay Control Circuit: Testing

  1. Turn ignition on, engine not running. Using the DRBIII®, actuate the Fuel Pump Relay. Is the Fuel Pump Relay clicking? If yes, go to next step. If no, go to step  3.
  2. WARNING: When the engine is operating, do not stand in a direct line with the fan. Do not put your hands near the pulleys, belts or fan. Do not wear loose clothing.
  3. The conditions that set the DTC are not present at this time. With the engine running at normal operating temperature, monitor the DRBIII® parameters related to the DTC while wiggling the wiring harness. Look for parameter values to change and/or a DTC to set. Review the DRBIII® Freeze Frame information. If possible, try to duplicate the conditions under which the DTC was set. Refer to any Technical Service Bulletins (TSB) that may apply. Visually inspect the related wiring harness. Look for any chafed, pierced, pinched, or partially broken wires. Visually inspect the related wiring harness connectors. Look for broken, bent, pushed out, or corroded terminals. Were any of the above conditions present? If yes, repair as necessary. If no, test is complete.
  4. Turn the ignition off. Remove the Fuel Pump Relay from the Power Distribution Center (PDC). PDC is located in left side of engine compartment. Check Fuel Pump Relay connector and clean/repair as necessary. Measure the resistance between Fuel Pump Relay terminals No. 1 (85) and No. 2 (86). Is the resistance 50-90 ohms? If yes, go to next step. If no, replace the Fuel Pump Relay.
  5. Disconnect the PCM harness connectors. Check PCM harness connectors and clean/repair as necessary. Measure the resistance of the Fuel Pump Relay Control circuit from the Fuel Pump Relay connector in the PDC to the PCM harness connector. Is the resistance less than 5.0 ohms? If yes, go to next step. If no, repair the open in the Fuel Pump Relay Control circuit.
  6. Measure the resistance between ground and the Fuel Pump Relay Control circuit in the Fuel Pump Relay connector in the PDC. Is the resistance less than 5 ohms? If yes, repair the short to ground in the Fuel Pump Relay Control circuit. If no, go to next step.
  7. Ensure ignition is off. Reconnect PCM harness connectors. Turn ignition on. Measure the voltage between ground and the Fused Ignition Switch Output circuit in the Fuel Pump Relay connector in the PDC. Is the voltage greater than 10 volts? If yes, go to next step. If no, repair the open or short to ground in the Fused Ignition Switch Output circuit. Inspect the related fuse and repair as necessary.
  8. There are no possible causes remaining, replace and program the Powertrain Control Module.