Door Lock Inhibit Inoperative
NOTE:
This testing only applies to models with vehicle theft security system.
Possible Causes:
- Door Ajar Scan Tool Read
- CTM Chime State
- CTM Key In Ignition Switch Sense
- Open Key In Ignition Switch Sense Circuit
- Ignition Switch
Testing
- Using scan tool, read DOOR AJAR SW status. Observe scan tool while opening and closing driver's side door. If scan tool display does not change from DOOR AJAR SW: OPEN to DOOR AJAR SW: CLOSED while opening and closing driver's side door, perform DRIVER'S SIDE DOOR AJAR CIRCUIT OPEN test under DOOR AJAR SYSTEM. If scan tool display changes from DOOR AJAR SW: OPEN to DOOR AJAR SW: CLOSED while opening and closing driver's side door, go to next step.
- Insert ignition key into ignition switch. Using scan tool, read KEY IN IGN CHIME STATE status. If scan tool displays KEY IN IGN CHIME STATE: ON, replace Central Timer Module (CTM). If scan tool does not display KEY IN IGN CHIME STATE: ON, go to next step.
- Ensure ignition is off. Leave key in ignition switch. Disconnect CTM connector C1. Measure resistance between terminal No. 9 (Light Blue wire) at CTM connector C1 and ground. See Figure . If resistance is less than 5 ohms, replace CTM. If resistance is more than 5 ohms, leave CTM connector C1 disconnected and go to next step.
- Separate joint connector No. 3, located behind headlight switch. Measure resistance between terminal No. 11 (Black/White wire) at joint connector No. 3 and ground. See Figure . If resistance is less than 5 ohms, replace ignition switch. If resistance is more than 5 ohms, repair open in key-in-ignition switch sense circuit.