Auxiliary Doors Fail To Lock
NOTE:
This testing only applies to models with vehicle theft security system.
Possible Causes:
- Auxiliary Door Scan Tool Read
- Side Auxiliary Door Switch
- Rear Auxiliary Door Switch
- Auxiliary Door Switch Sense Circuit
- Central Timer Module
Testing
- Ensure side and rear doors are fully closed. Turn ignition on. Using scan tool, read AUX DOOR AJAR SW status. If scan tool displays AUX DOOR AJAR SW: OPEN, perform ONE DOOR FAILING TO LOCK/UNLOCK FROM ANY SWITCH test. If scan tool does not display AUX DOOR AJAR SW: OPEN, go to next step.
- Disconnect side auxiliary door ajar switch connector. Using scan tool, read AUX DOOR AJAR SW status. If scan tool displays AUX DOOR AJAR SW: OPEN, replace side auxiliary door ajar switch. If scan tool does not display AUX DOOR AJAR SW: OPEN, go to next step.
- Disconnect rear auxiliary door ajar switch connector. Using scan tool, read AUX DOOR AJAR SW status. If scan tool displays AUX DOOR AJAR SW: OPEN, replace rear auxiliary door ajar switch. If scan tool does not display AUX DOOR AJAR SW: OPEN, go to next step.
- Turn ignition off. Disconnect Central Timer Module (CTM) connector C2. Measure resistance between terminal No. 15 (Brown/Tan wire) at CTM connector C2 and ground. See Figure . If resistance is less than 5 ohms, repair short to ground in auxiliary door switch sense circuit. If resistance is more than 5 ohms, replace CTM.