All Doors Failing To Unlock From Any Switch
NOTE:
This testing only applies to models with vehicle theft security system.
Possible Causes:
- Door Lock Driver Circuit Shorted To Voltage
- Door Unlock Driver Circuit Shorted To Ground
- Central Timer Module
Testing
- Turn ignition off. Disconnect Central Timer Module (CTM) connector C2. Turn ignition on. Measure voltage between terminal No. 1 (Orange/Black wire) at CTM connector C2 and ground. See Figure . If voltage is more than .1 volt, repair short to voltage in Orange/Black wire. If voltage is less than .1 volt, leave CTM connector C2 disconnected and go to next step.
- Measure resistance between terminal No. 1 (Orange/Black wire) at CTM connector C2 and ground. If resistance is less than 100 ohms, repair short to ground in Orange/Black wire. If resistance is more than 100 ohms, replace CTM.