Integrated Control Unit (ICU): Installation
- Install ICU onto its mounting bracket. Install 3 bolts attaching ICU to mounting bracket. Tighten 3 mounting bolts to a torque of 11 N m (97 INCH lbs.). Install primary and secondary brake tubes from master cylinder. See Figure . Using a crow foot on a torque wrench, tighten primary and secondary brake tube nuts to a torque of 17 N.m (145 INCH lbs.).
- Install three chassis brake tubes into their respective outlet ports on ICU hydraulic control unit. See . Using a crow foot on a torque wrench, tighten three brake tube nuts to a torque of 17 N.m (145 INCH lbs.).CAUTION: Before installing 25-way connector in CAB, be sure seal is properly installed in connector.
- Install 25-way connector into socket of CAB as follows:
- Position 25-way connector in socket of CAB and carefully push it down as far as possible.
- When connector is fully seated into CAB socket, push connector lock inward. This pulls connector into socket of CAB and locks it in installed position.
NOTE: The ICU may need to be initialized using DRBIII(R) scan tool after ICU installation. Refer to Appropriate Diagnostic Information. - Install front bumper and fascia, and hood. Connect negative battery cable. Remove brake pedal prop. Bleed base brakes and ABS hydraulic systems. Fill master cylinder to proper fill level. Road test vehicle to ensure proper operation of base and anti-lock brake systems.