LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2000 >> Durango 4.7 N, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Body Control Modules) >> System Tests >> Instrument Cluster >> Oil Pressure Gauge Not Operating Properly

Oil Pressure Gauge Not Operating Properly

WARNING: This page is about a different car, the 2000 Dodge Ram Wagon and 2000 Dodge Ram Van. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Perform BODY VERIFICATION TEST  under VERIFICATION TESTS after each repair.
  1. Turn ignition on. Using scan tool, attempt to communicate with instrument cluster. If scan tool does not communicate with instrument cluster, perform NO RESPONSE FROM INSTRUMENT CLUSTER  test under COMMUNICATIONS. If scan tool communicates with instrument cluster, go to next step.
  2. Turn ignition off. Push and hold trip/odometer reset button while turning ignition switch to RUN position. Release trip/odometer reset button to start self-test. Observe oil pressure gauge. Oil pressure gauge should reach following calibration points: "0", low end of normal, high end of normal, then 110. If oil pressure gauge reaches specified calibration points, check oil pressure sensor. Perform appropriate test(s) in appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE. If oil pressure gauge does not reach specified calibration points, replace instrument cluster. See ANALOG INSTRUMENT PANELS - RAM VAN & RAM WAGON article.