LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2000 >> Durango 4.7 N, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Body Control Modules) >> System Tests >> Instrument Cluster >> Any CCD Cluster Light Inoperative

Any CCD Cluster Light Inoperative

WARNING: This page is about a different car, the 2000 Dodge Ram Wagon and 2000 Dodge Ram Van. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Perform BODY VERIFICATION TEST  under VERIFICATION TESTS after each repair.
  1. Turn ignition off. Push and hold trip/odometer reset button while turning ignition switch to RUN position. Release trip/odometer reset button to start self-test. Observe inoperative light during self-test. If inoperative light does not illuminate during self-test, go to step  3. If inoperative light illuminates during self-test, turn ignition off and go to next step.
  2. Turn ignition on. Using scan tool, attempt to communicate with instrument cluster. If scan tool communicates with instrument cluster, test is complete. If scan tool does not communicate with instrument cluster, perform NO RESPONSE FROM INSTRUMENT CLUSTER  test under COMMUNICATIONS.
  3. Gain access to rear of instrument cluster. See ANALOG INSTRUMENT PANELS - RAM VAN & RAM WAGON article. Remove and inspect inoperative bulb and bulb socket. Repair or replace defective bulb or socket as necessary. If bulb and socket are okay, replace instrument cluster.