LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2000 >> Durango 4.7 N, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Body Control Modules) >> System Tests >> Communications >> No Bus Bias

No Bus Bias

WARNING: This page is about a different car, the 2000 Dodge Ram Wagon and 2000 Dodge Ram Van. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Ensure correct amperage fuse is being used.
NOTE: Perform BODY VERIFICATION TEST  under VERIFICATION TESTS after each repair.
NOTE: Unless instructed otherwise in test step, reconnect any previously disconnected components and connectors.
  1. Turn ignition off. Disconnect scan tool from Data Link Connector (DLC). Turn ignition on. Using an external voltmeter, check voltage between DLC terminals No. 3, CCD bus (+) circuit (Violet/Brown wire) and No. 11, CCD bus (-) circuit (White/Black wire). See Figure. If voltage is 1.8-2.8 volts, replace scan tool or scan tool cable as necessary. If voltage is not 1.8-2.8 volts, go to next step.
  2. Inspect fuse No. 1 (15-amp), fused ignition switch output run/accessory circuit (Red/Tan wire) in fuse block. Fuses are identified on fuse block cover. If fuse is okay, go to next step. If fuse is open, use wiring diagram as a guide to inspect wiring and components related to this circuit for possible cause of open fuse. See WIRING DIAGRAMS . Also see appropriate wiring diagram in POWER DISTRIBUTION article in WIRING DIAGRAMS.
  3. Turn ignition off. Remove instrument cluster. See ANALOG INSTRUMENT PANELS - RAM VAN & RAM WAGON article. Clean and repair connectors as necessary and go to next step.
  4. Turn ignition on. Check voltage on instrument cluster C1 Green connector terminal No. 6, fused B (+) circuit (Pink/White wire). See Figure. If voltage is more than 10 volts, leave instrument cluster removed and go to next step. If voltage is 10 volts or less, repair open Pink/White wire.
  5. Turn ignition off. Check resistance of instrument cluster C1 connector terminal No. 4, ground circuit (Black/Dark Green wire) and instrument cluster C2 Blue connector terminal No. 7, ground circuit (Black wire). If resistance is less than 5 ohms on both circuits, leave instrument cluster removed and go to next step. If resistance is 5 ohms or more on either circuit, repair open or high resistance in Black and/or Black/Dark Green wire(s).
  6. Using an external ohmmeter, check resistance between ground and instrument cluster C1 Green connector terminal No. 9, CCD bus (-) circuit (White/Black wire). See Figure. Check resistance of instrument cluster C1 connector terminal No. 10, CCD bus (+) circuit (Violet/Brown wire). If resistance is 700 ohms or more on both circuits, leave instrument cluster removed and go to next step. If resistance is less than 700 ohms on either circuit, repair short to ground in Violet/Brown and/or White/Black wire(s).
  7. Ensure ignition is off. Remove scan tool from DLC. Using ohmmeter, check resistance of CCD bus (+) circuit (Violet/Brown wire) between instrument cluster C1 connector terminal No. 10 and DLC terminal No. 3. If resistance is less than 5 ohms, leave scan tool and instrument cluster removed, and go to next step. If resistance is 5 ohms or more, repair open Violet/Brown wire.
  8. Using ohmmeter, check resistance of CCD bus (-) circuit (White/Black wire) between DLC terminal No. 11 and instrument cluster C1 connector terminal No. 9. If resistance is less than 5 ohms, replace instrument cluster. If resistance is 5 ohms or more, repair open White/Black wire.