LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2000 >> Durango 4.7 N, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Body Control Modules) >> System Tests >> Chime System >> Chime Remains On With Ignition On

Chime Remains On With Ignition On

WARNING: This page is about a different car, the 2000 Dodge Ram Wagon and 2000 Dodge Ram Van. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Perform BODY VERIFICATION TEST  under VERIFICATION TESTS after each repair.
NOTE: Unless instructed otherwise in test step, reconnect any previously disconnected components and connectors.
  1. Turn ignition off. Disconnect Central Timer Module (CTM) C1 Green connector. Disconnect instrument cluster C2 Blue connector. Using an external ohmmeter, check resistance of tone request signal circuit (Dark Blue/Red wire) between CTM C1 Green connector terminal No. 2 and instrument cluster C2 connector terminal No. 4. See Figure and Figure . If resistance is less than 5 ohms, repair short to ground in Dark Blue/Red wire. If resistance is 5 ohms or more, go to next step.
  2. Ensure headlight switch is not turned all the way counterclockwise. Ensure all doors are closed and courtesy/dome lights are off. Ensure no gauge HI/LO warnings or warning light conditions exist. Turn ignition on, wait 10 seconds, then go to next step.
  3. Remove instrument cluster. See ANALOG INSTRUMENT PANELS - RAM VAN & RAM WAGON article. If chime stops, replace instrument cluster. If chime does not stop, go to next step.
  4. Remove ignition key. Disconnect C201 connector. Using external ohmmeter, check resistance between C201 Black connector terminals B3, driver's door ajar switch sense circuit (Black/White wire) and B4, key-in ignition switch sense circuit (Light Blue wire). See Figure. If resistance is less than 10 ohms, replace ignition switch. If resistance is 10 ohms or more, go to next step.
  5. Open driver's door. Turn headlights on. Using scan tool, read DR DOOR AJAR SW status and IGNITION CHIME STATE. If scan tool displays DR DOOR AJAR SW: CLOSED and IGNITION CHIME STATUS: ON, replace CTM. If scan tool does not display DR DOOR AJAR SW: CLOSED and IGNITION CHIME STATUS: ON, go to next step.
  6. Gain access to back of headlight switch, through instrument cluster opening. Remove headlight switch. Disconnect headlight switch connectors. Turn headlight switch on. Using an external ohmmeter, check resistance across headlight switch (component side) terminals B3 and "U". See Figure. If resistance is more than one ohm, replace headlight switch. If resistance is one ohm or less, replace CTM.