LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2000 >> Durango 4.7 N, Part Time >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Diagnostic Procedures - Trucks & RWD Vans - Gasoline >> Fuel System >> Fuel Pressure Release >> All Models

All Models

  1. Remove gas cap. Using a non-metallic tool, open flapper valve in filler neck to relieve pressure. Remove fuel pump relay from Power Distribution Center (PDC). Relays are identified on label under PDC cover. Start and run engine until it stalls. Attempt to start engine. Continue restarting engine until it will no longer run. Turn ignition off.
    CAUTION: DO NOT supply power to fuel injector for more than 4 seconds, or fuel injector may be damaged.
  2. NOTE: Procedures in step  1 should be performed to release high fuel system pressure from fuel rail. DO NOT attempt to use the following procedure to release high fuel system pressure, as excessive fuel may be forced into engine cylinder.
  3. Disconnect any fuel injector connector. Connect a jumper wire between either fuel injector terminal and positive battery terminal. Connect another jumper wire to other fuel injector terminal. Momentarily touch other end of jumper wire to negative battery terminal.
  4. Place a shop towel under fuel line quick-connector at fuel rail. Use care when disconnecting fuel lines, as some fuel pressure may still exist in fuel lines. Disconnect fuel line quick-connector. Reinstall fuel pump relay in PDC. Clear DTCs from PCM. To clear DTCs from PCM, see CLEARING DTCS under SELF-DIAGNOSTIC SYSTEM in appropriate SELF-DIAGNOSTICS article.