Power Distribution Center
CAUTION:
When replacing a blown fuse, it is important to use only a fuse having the correct amperage rating. The use of a fuse with a rating other than indicated may result in a dangerous electrical system overload. If a properly rated fuse continues to blow, it indicates a problem in the circuit that must be corrected.
NOTE:
If you are leaving your vehicle dormant for longer than 21 days you may want to take steps to protect your battery. You may do this by disconnecting the battery or by disconnecting the Ignition-Off Draw (IOD) fuse in cavity No. 12. The IOD cavity includes a snap-in retainer that allows the fuse to be disconnected, without removing it from the fuse block. Pressing the IOD fuse back into the cavity reconnects it.
A Power Distribution Center (PDC) is located in the engine compartment. See Fig 1 . For fuse identification, see POWER DISTRIBUTION FUSE IDENTIFICATION table. For fuse identification, see Fig 2 .
POWER DISTRIBUTION FUSE IDENTIFICATION
| Fuse (Amp) | Application |
|---|---|
| A (15) | Powertrain Control Module, Fuel Injector/Coil On Plug 1, 2, 3, 4, 5, 6, 7, 8, Ignition Coil, Oxygen Sensors & Capacitors 1 & 2 |
| B (20) | Transmission Control Relay & Transmission Control Module |
| C (20) | Fog Lamp Relay, Left/Right Fog Lamp & Daytime Running Lamp |
| D (20) | Brake Lamp Switch |
| E (15) | Left Headlamp |
| F (25) | Combination Flasher |
| G (15) | Right Headlamp |
| 1 (20) | Powertrain Control Module, Fuel Pump Relay & Fuel Pump Module |
| 2 (30) | Radiator Fan Relay |
| 3 (30) | Automatic Shut Down Relay |
| 4 (50) | Power Seat Switch & Rear Wiper/Defogger Switch |
| 5 (40) | Blower Motor Relay |
| 6 (50) | Relay/Fuse Block, Electric Brake & Trailer Tow Connector |
| 7 (40) | Junction Block |
| 8 (40) | Controller Anti-Lock Brake |
| 9 (50) | Ignition Switch & Engine Starter Motor Relay |
| 10 (40) | Ignition Switch |