LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 2000 >> Durango 4.7 N, Part Time >> Repair and Diagnosis >> Body & Frame >> Power Mirrors >> System Tests >> Automatic Day/Night Inside Mirror

Automatic Day/Night Inside Mirror

  1. Turn ignition switch to ON position with transmission in Neutral or Park. Place mirror switch in ON position (switch LED illuminated). Cover forward facing sensor with a dark cloth or tape to exclude any ambient light. See Fig 1 .
  2. Shine a light into rear-facing sensor. Observe whether or not mirror darkens. With mirror darkened, place transmission in Reverse. Mirror should return to normal. If conditions are met, mirror is operating correctly. If conditions are not met, remove covering from sensor and go to next step.
  3. Check fuse No. 11 (10-amp) in junction block. Repair any short circuits and replace fuse as necessary. Go to next step.
  4. Check for power at fuse. Repair open circuits as necessary. See WIRING DIAGRAMS  . If power exists, go to next step.
  5. Disconnect negative battery cable. Disconnect mirror harness connector. Check continuity between harness connector terminal No. 2 (Black wire) and ground. If continuity exists, go to next step. If continuity does not exist, repair open in Black wire between mirror and ground.
  6. Reconnect battery cable. Turn ignition on. Check for voltage at harness connector terminal No. 1 (Dark Blue/White wire). If battery voltage exists, go to next step. If battery voltage does not exist, repair open in circuit between mirror and fuse No. 11.
  7. Set parking brake. Put transmission selector in Reverse. Check for voltage at harness connector terminal No. 3 (Violet/Black wire). If battery voltage exists, go to next step. If battery voltage does not exist, repair open in circuit between mirror and Park/Neutral Position (PNP) switch (automatic) or back-up light switch (manual). See WIRING DIAGRAMS  .
  8. Turn ignition off. Reconnect mirror harness connector. Turn ignition on. Put transmission selector in Neutral. Completely cover forward facing light sensor. Shine a light in rear facing light sensor, located at top center of mirror. If mirror glass darkens, go to next step. If mirror glass does not darken, replace mirror.
  9. With light still on, put transmission selector in Reverse. Mirror should lighten. If mirror glass does not lighten, replace mirror.
Fig 1: Identifying Automatic Day/Night Mirror
G99C02062Courtesy of CHRYSLER CORP.