Power Mirror Motor
Disconnect harness connector from power mirror switch. Using 2 jumper wires, connect one jumper to a 12-volt source and the other to a good ground. Apply power and ground to power mirror switch harness connector. See POWER MIRROR MOTOR TEST table. See Fig 1 . If mirror does not operate as specified, check for open or shorted circuit, or replace mirror assembly as necessary.
POWER MIRROR MOTOR TEST
| Apply 12 Volts To Switch Connector Terminal No. (1) | Ground Terminal No. | Mirror Operation | ||
|---|---|---|---|---|
| 3 | 1 | Up | ||
| 2 | 1 | Left | ||
| 1 | 3 | Down | ||
| 1 | 2 | Right | ||
|
||||