Test VER-5A
NOTE:
If PCM has been replaced and correct VIN and mileage have not been programmed, a DTC will be set in ABS and air bag modules. If vehicle is equipped with a Sentry Key Immobilizer Module (SKIM), sentry key data must be updated to enable starting. See COMPUTER RELEARN PROCEDURES article in GENERAL INFORMATION.
- If vehicle is not equipped with a diesel engine, go to next step. If vehicle is equipped with a diesel engine, and PCM has been disconnected or replaced, battery has been disconnected, or Accelerator Pedal Position Sensor (APPS) has been disconnected or replaced, APPS calibration must be programmed into PCM (diesel only). Turn ignition on. Slowly press accelerator pedal to floor and slowly release. DO NOT attempt to adjust screws or disassemble APPS. Go to next step.
- On all engines, if vehicle is equipped with ABS or air bag, enter correct VIN and mileage in PCM. Erase DTCs in ABS and air bag modules. Inspect vehicle to ensure all engine and speed control system components are connected.
- If there are any DTCs that have not been repaired, go to SELF-DIAGNOSTIC SYSTEM . After all DTCs have been repaired, run appropriate monitor for previously repaired DTC.
- Connect scan tool to DLC. Ensure fuel tank is at least 1/4 full. Turn off all accessories. Allow PCM to run appropriate monitor and increment appropriate good trip. Enabling conditions must be met before monitor will run.
- Using scan tool, monitor pretest enabling conditions until all conditions have been met. Once enabling conditions have been met, monitor appropriate monitor.
- If repaired DTC has reset or was seen in monitor while on road test, repair is not complete. Check for TSBs or flash updates and return to TROUBLE SHOOTING .
- If appropriate monitor ran, good trip counter incremented and no DTCs have been set, repair is complete.