LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 1996 >> Intrepid ES >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 3.3L >> Self-Diagnostic Tests >> Test TC-70C - Injector No. 6 Control Circuit

Test TC-70C - Injector No. 6 Control Circuit

NOTE: For connector terminal ID, see CONNECTOR IDENTIFICATION DIRECTORY  table. For wiring diagram, see WIRING DIAGRAMS article.
  1. It may be necessary to remove intake plenum for access to injector connectors. Reconnect junction block No. 2 connector. Disconnect injector No. 6 connector. Turn ignition on. Using scan tool, actuate ASD relay. Using scan tool in voltmeter mode, check voltage on injector No. 6 connector Dark Green/Orange wire. If voltage cycles high and low, go to next step. If voltage does not cycle high and low, repair open Dark Green/Orange wire. Perform TEST VER-2A - ROAD TEST VERIFICATION  .
  2. Turn ignition off. Using an external ohmmeter, check resistance of Brown/Black wire between injector No. 6 connector and junction block No. 1 connector (injector side). If resistance is less than 5 ohms, replace injector No. 6. Perform TEST VER-2A - ROAD TEST VERIFICATION  . If resistance is 5 ohms or more, repair open Brown/Black wire. Perform TEST VER-2A - ROAD TEST VERIFICATION  .