Test TC-69D - Injector No. 5 Control Circuit
NOTE:
For connector terminal ID, see CONNECTOR IDENTIFICATION DIRECTORY
table. For wiring diagram, see WIRING DIAGRAMS
article.
- It may be necessary to remove intake plenum for access to injector connectors. Reconnect junction block No. 2 connector. Disconnect injector No. 5 connector. Turn ignition on. Using scan tool, actuate ASD relay. Using scan tool in voltmeter mode, check voltage on injector No. 5 connector Dark Green/Orange wire. If voltage cycles high and low, go to next step. If voltage does not cycle high and low, repair open Dark Green/Orange wire. Perform TEST VER-2A - ROAD TEST VERIFICATION .
- Turn ignition off. Using an external ohmmeter, check resistance of Brown/Red wire between injector No. 5 connector and junction block No. 1 connector (injector side). If resistance is less than 5 ohms, replace injector No. 5. Perform TEST VER-2A - ROAD TEST VERIFICATION . If resistance is 5 ohms or more, repair open Brown/Red wire. Perform TEST VER-2A - ROAD TEST VERIFICATION .