LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 1996 >> Intrepid ES >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 3.3L >> Self-Diagnostic Tests >> Test TC-69C - Injector No. 5 Control Circuit

Test TC-69C - Injector No. 5 Control Circuit

NOTE: For connector terminal ID, see CONNECTOR IDENTIFICATION DIRECTORY  table. For wiring diagram, see WIRING DIAGRAMS article.
  1. Turn ignition off. Disconnect junction block No. 1 and 2 connectors. See Fig 1 .
    Fig 1: Junction Block Connectors
    G96H01531
  2. Using an external ohmmeter, check resistance of injector No. 5 driver circuit between junction block No. 1 connector (injector side) Brown/Red wire and junction block No. 2 connector (injector side) Black wire. See Fig 1 . If resistance is 10-15 ohms, go to next step. If resistance is not 10-15 ohms, perform TEST TC-69D  .
  3. Move one ohmmeter lead from junction block No. 2 connector (injector side) Black wire to ground. If ohmmeter displays 5 ohms or more, go to next step. If ohmmeter displays less than 5 ohms, repair short to ground on junction block No. 1 connector (injector side) Brown/Red wire. Perform TEST VER-2A - ROAD TEST VERIFICATION  .
  4. Turn ignition on. Using scan tool, actuate ASD relay. Using scan tool in voltmeter mode, check voltage on junction block No. 2 connector (PCM side) ASD relay output circuit Dark Green/Orange wire. If voltage cycles high and low, go to next step. If voltage does not cycle high and low, repair open ASD relay output circuit. Perform TEST VER-2A - ROAD TEST VERIFICATION  .
  5. Turn ignition off. Disconnect Powertrain Control Module (PCM) connector. Using scan tool in ohmmeter mode, check resistance of PCM connector terminal No. 15 (Brown/Red wire). If resistance is 5 ohms or more, go to next step. If resistance is less than 5 ohms, repair short to ground on Brown/Red wire. Perform TEST VER-2A - ROAD TEST VERIFICATION  .
  6. Using an external ohmmeter, check resistance of Brown/Red wire between PCM connector terminal No. 15 and junction block No. 1 connector (PCM side). If resistance is less than 5 ohms, replace PCM. Perform TEST VER-2A - ROAD TEST VERIFICATION  . If resistance is 5 ohms or more, repair open Brown/Red wire. Perform TEST VER-2A - ROAD TEST VERIFICATION  .