LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 1996 >> Intrepid ES >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 3.3L >> Self-Diagnostic Tests >> Test TC-61B - Injector No. 4 Control Circuit

Test TC-61B - Injector No. 4 Control Circuit

NOTE: For connector terminal ID, see CONNECTOR IDENTIFICATION DIRECTORY  table. For wiring diagram, see WIRING DIAGRAMS article.
  1. Disconnect junction block No. 1 and 2 connectors. See Fig 1 . Using an external ohmmeter, check resistance of injector No. 4 driver circuit between junction block No. 1 connector (injector side) Light Blue/Brown wire and junction block No. 2 connector (injector side) Black wire. See Fig 1 . If resistance is 10-15 ohms, go to next step. If resistance is not 10-15 ohms, perform TEST TC-61C - INJECTOR NO. 4 CONTROL CIRCUIT  .
    Fig 1: Junction Block Connectors
    G96H01531
  2. Move one ohmmeter lead from junction block No. 2 connector (injector side) Black wire to ground. If ohmmeter displays 5 ohms or more, go to next step. If ohmmeter displays less than 5 ohms, repair short to ground on Light Blue/Brown wire between junction block No. 1 connector (injector side) and injector No. 4 connector. Perform TEST VER-2A - ROAD TEST VERIFICATION  .
  3. Turn ignition on. Using scan tool, actuate ASD relay. Using scan tool in voltmeter mode, check voltage on junction block No. 2 connector (PCM side) ASD relay output circuit Dark Green/Orange wire. If voltage cycles high and low, go to next step. If voltage does not cycle high and low, repair open ASD relay output circuit between junction block No. 2 connector and PCM connector. Perform TEST VER-2A - ROAD TEST VERIFICATION  .
  4. Turn ignition off. Disconnect Powertrain Control Module (PCM) connector. Using scan tool in ohmmeter mode, check resistance of PCM connector terminal No. 16 (Light Blue/Brown wire). If resistance is 5 ohms or more, go to next step. If resistance is less than 5 ohms, repair short to ground on Light Blue/Brown wire. Perform TEST VER-2A - ROAD TEST VERIFICATION  .
  5. Using an external ohmmeter, check resistance of Light Blue/Brown wire between PCM connector terminal No. 16 and junction block No. 1 connector (PCM side). If resistance is less than 5 ohms, replace PCM. Perform TEST VER-2A - ROAD TEST VERIFICATION  . If resistance is 5 ohms or more, repair open Light Blue/Brown wire. Perform TEST VER-2A - ROAD TEST VERIFICATION  .