Test TC-19C - Injector No. 3 Control Circuit
NOTE:
For connector terminal ID, see CONNECTOR IDENTIFICATION DIRECTORY
table. For wiring diagram, see WIRING DIAGRAMS
article.
- Turn ignition off. Disconnect junction block No. 1 and 2 connectors. See Fig 1 .
- Using an external ohmmeter, check resistance of injector No. 3 driver circuit between junction block No. 1 connector (injector side) Yellow/White wire and junction block No. 2 connector (injector side) Black wire. See Fig 1 . If resistance is 10-15 ohms, go to next step. If resistance is not 10-15 ohms, perform TEST TC-19D .
- Move one ohmmeter lead from junction block No. 2 connector (injector side) Black wire to ground. If ohmmeter displays 5 ohms or more, go to next step. If ohmmeter displays less than 5 ohms, repair short to ground on junction block No. 1 connector (injector side) Yellow/White wire. Perform TEST VER-2A - ROAD TEST VERIFICATION .
- Turn ignition on. Using scan tool, actuate ASD relay. Using scan tool in voltmeter mode, check voltage on junction block No. 2 connector (PCM side) ASD relay output circuit Dark Green/Orange wire. If voltage cycles high and low, go to next step. If voltage does not cycle high and low, repair open ASD relay output circuit. Perform TEST VER-2A - ROAD TEST VERIFICATION .
- Turn ignition off. Disconnect Powertrain Control Module (PCM) connector. Using scan tool in ohmmeter mode, check resistance of PCM connector terminal No. 7 (Yellow/White wire). If resistance is 5 ohms or more, go to next step. If resistance is less than 5 ohms, repair short to ground on Yellow/White wire. Perform TEST VER-2A - ROAD TEST VERIFICATION .
- Using an external ohmmeter, check resistance of Yellow/White wire between PCM connector terminal No. 7 and junction block No. 1 connector (PCM side). If resistance is less than 5 ohms, replace PCM. Perform TEST VER-2A - ROAD TEST VERIFICATION . If resistance is 5 ohms or more, repair open Yellow/White wire. Perform TEST VER-2A - ROAD TEST VERIFICATION .