LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 1981 >> Cutaway >> Repair and Diagnosis >> Engine Performance >> Ignition System >> Electronic Ignition >> Testing >> Wiring Harness & Connector

Wiring Harness & Connector

Measure voltage across battery terminals, record this measurement. Turn ignition switch "OFF", then disconnect harness connector from control unit. Connect voltmeter negative lead to a good ground and then turn ignition "ON". Make checks as follows.

  1. Connect voltmeter positive lead to control unit harness connector cavity 1. Reading should be battery voltage. If not, check and repair wires and components from harness connector cavity 1 back to battery. See Fig 1 and Fig 2.
    Fig 1: Checking Voltage at Cavity No. 1
    G09337339Courtesy of CHRYSLER GROUP, LLC
    Fig 2: Circuitry Checked if Cavity No. 1 Reading is Not to Specifications
    G09337340Courtesy of CHRYSLER GROUP, LLC
  2. With voltmeter negative lead still connected to ground, connect positive lead to harness connector cavity 2. Voltmeter should again read battery voltage. If reading is not to specification, check voltage at each connection (coil negative terminal, coil positive terminal, ballast resistor, ignition switch, etc.) back to battery. Repair wiring or replace components as necessary. See Fig 3 and Fig 4.
    Fig 3: Checking Voltage at Cavity No. 2
    G09337341Courtesy of CHRYSLER GROUP, LLC
    Fig 4: Circuitry Checked if Cavity No. 2 Reading Is Not to Specifications
    G09337342Courtesy of CHRYSLER GROUP, LLC
  3. If reading jumped to battery voltage on positive side of ignition coil, check coil primary and secondary resistance. If coil is bad, replace it. Also check ballast resistor by disconnecting wires from resistor and then taking an ohmmeter reading across its 2 terminals. Resistance should be 1.12-1.38 ohms. If reading is not to specifications, replace ballast resistor. See Fig 5.
    Fig 5: Checking Ballast Resistor Resistance
    G09337343Courtesy of CHRYSLER GROUP, LLC