LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 1981 >> Colt RS, Standard Trans >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Columns >> Removal & Installation >> Steering Column >> Installation

Steering Column: Installation

  1. Install dust cover to intermediate shaft. Make sure bearing side of cover faces steering shaft side of intermediate shaft. See  Fig 1  and 3. 
    Fig 1: Determining Correct Intermediate Shaft Installation Position
    G09358238Courtesy of CHRYSLER GROUP, LLC
  2. Apply grease to bearing and dust cover, then install bearing (two pieces) into dust cover. Attach intermediate shaft lower joint to steering gear and temporarily tighten dust cover bolts. Now tighten lower joint clamp bolt.
    Fig 2: Dust Cover And Bearing Installation
    G09358239Courtesy of CHRYSLER GROUP, LLC
  3. Connect intermediate shaft upper joint to steering shaft. Attach steering column brackets to dash. Tighten clamp bolt of intermediate shaft and column bracket bolts.
  4. Loosen dust cover bolts and position dust cover so no clearance exists between joint and dust cover sliding surfaces. Tighten dust cover bolts. Adjust steering wheel position if necessary.