LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 1972 >> Colt Not Available, Not Available Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Colt Engines >> Valve Guide Servicing

Valve Guide Servicing

  1. Check valve stem-to-guide clearance. If clearance exceeds service limit (0.004" for intake; 0.006" for exhaust), replace with next oversize component. Valve stem-to-guide clearance can be obtained from the difference between ID of the guide and OD of valve stem. Guides are available in the following over-sizes:
    VALVE GUIDE OVERSIZE

    Size Mark(1) Oversize In. (mm) Cyl. Head Hole Size In. (mm)
    5 002 (.05) 5138-.5145 (13.050-13.0683)
    25 010 (.25) 5216-.5224 (13.2486-13.2689)
    50 020 (.50) 5315-.5323 (13.5001-13.5204)
    (1) Intake and exhaust guides.
    Fig 1: Valve Guide Installation
    G09325609Courtesy of CHRYSLER GROUP, LLC
  2. Heat cylinder head to approximately 482°F. Using suitable valve guide tool, drive or hammer out each guide toward combustion chamber. Ream guide hole to specified size at normal temperature.
    Fig 2: Valve Stem Oil Seal Installation
    G09325610Courtesy of CHRYSLER GROUP, LLC
  3. To install, heat head to approximately 482°F. Insert guides and quickly drive into head. Remove any burrs on lower end of guides. Guide should protrude 0.539 - 0.563" above head (see Fig 2). Check ID and ream if necessary.