LEMON Manuals: Even more car manuals for everyone
Home >> Dodge and Ram >> 1971 >> Colt Not Available, Not Available Trans >> Repair and Diagnosis >> Engine Performance >> Tune-Up >> Tune-Up - V8 >> Distributor

Tune-Up - V8: Distributor

DISTRIBUTOR CAM ANGLE NOTE: On all engines vacuum advance hose must be disconnected to check cam angle. 383" & 440" engines are equipped with a distributor vacuum advance retarding solenoid. When checking cam angle, wire from solenoid to carburetor must be disconnected at CARBURETOR end. Do not try to energize solenoid while unit is off engine  .

Point Gap 318", 340" & 360"(1) .014"-.019"
  383" .016"-.021"
  440" (Exc. 3 2-Bbl.) .016"-.021"
  440" (3 2-Bbl.) & 426" .014"-.019"
(1) - Set individual points to 27°-32° for a combined dwell of 37°-42°.
(1) Except 340" W/Electronic Ignition System, See ELECTRICAL  Section.
Engine Cam Angle
Synchro-mesh Auto. Trans.
318" 30°-34° 30°-34°
340" (2) (1) 30°-34°
360" 30°-34° 30°-34°
383" 28.5°-32.5° 28.5°-32.5°
440 (Exc. 3 2-Bbl.) 28.5°-32.5° 28.5°-32.5°
  (3 2-Bbl.) (1) (1)
426" (1) (1)
Breaker Arm Spring Tension
  Single Breaker 17-20 ozs.
  Double Breaker 17-21 1/2 ozs.
Condenser Capacity (All) .25-.28S mfd.
(1) Set individual points to 27°-32° for a combined dwell of 37°-42°.
(2) Except 340" W/Electronic Ignition System, See ELECTRICAL  Section.